Acadian

If you are having the same issue I was, where it would see my wireless AP and try to connect, but fail then edit IP and DNS and change MTU to lowest 576.

So once it tries to connect to the AP it will fail, then at the top right tap the change settings, then scroll over to IP Address and change it from automatic to manual and enter the info below. Do the same for DNS.

If you want to know wha t DNS and gateway to use.. go to command prompt and type ipconfig /all scroll to the top and you will see the IP of your computer. If it's say 192.168.0.100 then choose something around 192.168.0.30 as most likely the higher range is reserved for DHCP. Put the gateway and DNS listed in Ipconfig.

I had to set MTU to 576 for mine to work.